Jump to content
  • 2
Andy Broomell

Offset Mode Buttons

Question

I desperately want the Offset tool to have a simple mode button to turn on/off the option to "Close Open Curves". It's annoying having to go into the tool preferences every time I want to switch it on or off, which seems to be every time I use the tool.

I suppose there should be a mode button for "Smooth Corners" too, though I don't personally use that option much.

Less clicking!

Share this post


Link to post

6 answers to this question

Recommended Posts

  • 0

Bump.

Bummed to see this still not implemented. I know I've seen other requests for this on the forum. It's literally just adding a button, and would save people lots of time.

I probably clicked the settings button three or four hundred times today to turn "close open curves" on and off...

Share this post


Link to post
  • 0

Absolutely needed.  Buttons for Close Open Curves and Smooth Corners would remove the need for a preferences button completely.  I'm fairly sure I filed an enhancement request for this years back.  I searched for it but I haven't been able to find it.

Another obvious need is a button to switch between the Polygon and Line modes for the Double Line and Double Polygon tools.  These I have filed an enhancement request for.

Share this post


Link to post
  • 0
5 hours ago, mike m oz said:

Absolutely needed.  Buttons for Close Open Curves and Smooth Corners would remove the need for a preferences button completely.  I'm fairly sure I filed an enhancement request for this years back.  I searched for it but I haven't been able to find it.

Another obvious need is a button to switch between the Polygon and Line modes for the Double Line and Double Polygon tools.  These I have filed an enhancement request for.

 

Tack it on to the UI refresh.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...