So I have multiple design layers for stage 1 and stage 2 of a project (with the same baseplan).
I am using classes to turn off/on reveal the objects needed for stage 1 and stage 2 in design layers separately.
I am a newbie and I figured this is possible but I am struggling to figure this out.
Details below:
I have 3 Design layers
Design layer 1 shows the baseplan and shows no classes.
(Even though all classes are set to visible) this is good, this is what I want.
Design layer 2 shows:
The baseplan
My "stage 1 classes"
and none of the "stage 2 classes"
(Again, all classes are set to visible)
This is ok this is what I want...
But Design layer 3 for some reason, shows ALL of the "stage 1 classes" AS WELL AS the "stage 2 classes"
(Again, all classes visible)
I'm wondering why I am able to assign certain classes to the first two design layers, but the third Design layer I cannot seem to turn off some classes without losing them on another Design layer.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
anixo
So I have multiple design layers for stage 1 and stage 2 of a project (with the same baseplan).
I am using classes to turn off/on reveal the objects needed for stage 1 and stage 2 in design layers separately.
I am a newbie and I figured this is possible but I am struggling to figure this out.
Details below:
I have 3 Design layers
Design layer 1 shows the baseplan and shows no classes.
(Even though all classes are set to visible) this is good, this is what I want.
Design layer 2 shows:
The baseplan
My "stage 1 classes"
and none of the "stage 2 classes"
(Again, all classes are set to visible)
This is ok this is what I want...
But Design layer 3 for some reason, shows ALL of the "stage 1 classes" AS WELL AS the "stage 2 classes"
(Again, all classes visible)
I'm wondering why I am able to assign certain classes to the first two design layers, but the third Design layer I cannot seem to turn off some classes without losing them on another Design layer.
Link to comment
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.