So I have multiple design layers for stage 1 and stage 2 of a project (with the same baseplan).
I am using classes to turn off/on reveal the objects needed for stage 1 and stage 2 in design layers separately.
I am a newbie and I figured this is possible but I am struggling to figure this out.
Details below:
I have 3 Design layers
Design layer 1 shows the baseplan and shows no classes.
(Even though all classes are set to visible) this is good, this is what I want.
Design layer 2 shows:
The baseplan
My "stage 1 classes"
and none of the "stage 2 classes"
(Again, all classes are set to visible)
This is ok this is what I want...
But Design layer 3 for some reason, shows ALL of the "stage 1 classes" AS WELL AS the "stage 2 classes"
(Again, all classes visible)
I'm wondering why I am able to assign certain classes to the first two design layers, but the third Design layer I cannot seem to turn off some classes without losing them on another Design layer.