I draw my window casings in profile as 1/2" x 2-1/4" with 1/8" filleted out side edges. Like this:
Then I extrude them.
Next I want to miter the ends. I tried the Split tool and that works, but it creates a solid section, and I don't know if that is good or bad. Is there a better way to cut these mitered ends?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Bruce Kieffer
I draw my window casings in profile as 1/2" x 2-1/4" with 1/8" filleted out side edges. Like this:
Then I extrude them.
Next I want to miter the ends. I tried the Split tool and that works, but it creates a solid section, and I don't know if that is good or bad. Is there a better way to cut these mitered ends?
Edited by Bruce KiefferLink to comment
12 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.