Site Model has 'edges'

[hollister design Studio 30]

I keep getting 'edges' on my site models.

 

Yellow Highlighter:

 

I'm trying to use the split tool to clean up the edge of the topo lines before I convert, but this still seems to happen often.

 

Thoughts on what I'm doing wrong?

Ways to fix this?

Should I just crop the edge out?

 

Here are the original topo 3D polylines:

 

 

 

[Tom W. 139]

Good question. I've had this too + wondered why it was happening. I just cropped the offending edge/s out like you say but be good to know why it happens + if anything can be done to prevent it

[jpccrodrigues 22]

Hi, 

 

You either edit your site model crop or you add some 3d loci in the recreate from site model source tool. It should work out 

[Tom W. 139]

Hi @jpccrodrigues so pretty much what I was doing already + no trick to prevent it happening in first place. I can live with that! Thanks

[zoomer 1,012]

Yes, I also just crop a bit inside.

 

Generally you can fixit manually of course by following the edge flow

and adding a few missing or deleting a few redundant points and such.

Sometimes I have that ambition - but this is basically just pointless 🙂

Just crop it a bit off and you are fine.

[hollister design Studio 30]

I figured - tried to fix it and made it even worse!

Cropping it is.

 

Thanks everyone.

[CipesDesign 148]

Agree with all of the above. For most single family residential sites I ask the surveyor to include extra area in the topographic data so that I can crop out the weird random anomalies at the edge(s).