ERik Smith Posted February 12 Share Posted February 12 I'm trying to figure out the 2024 version of the Align and distribute tool........can't seem to figure this version out. Can't get a motor or fixture to replicate along a truss.....any thoughts? Quote Link to comment
Vectorworks, Inc Employee TomWhiteLight Posted February 14 Vectorworks, Inc Employee Share Posted February 14 Align and Distribute will only align what's already there. I think you mean 'Move by Points' Quote Link to comment
Sam Jones Posted February 15 Share Posted February 15 9 hours ago, TomWhiteLight said: I think you mean 'Move by Points' Nope. I mean "Duplicate Array...", but "Move by Points" will work except in its first mode. Quote Link to comment
Jonathan Pickup Posted February 15 Share Posted February 15 Here is a movie on the move by points tool Quote Link to comment
Vectorworks, Inc Employee TomWhiteLight Posted February 15 Vectorworks, Inc Employee Share Posted February 15 Thanks Johnathan. I was referring to Erik @Sam Jones Move by points was the only 'tool' I could think of. Quote Link to comment
Vectorworks, Inc Employee Scott C. Parker Posted February 15 Vectorworks, Inc Employee Share Posted February 15 Three ways I use to duplicate hoists along a truss. Move by points. Duplicate Array. Duplicate along Path. The key is that the points/paths must be along the truss's centerline. Here's a video showing all three. Duplicate Hoists Along Truss 3 Ways-1.mp4 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.