If the stair manufacturer can do it, Vectorworks should be able to do it.
But I'm pretty sure this stair geometry is impossible with the Stair Tool so I thought I'd throw it open to see if anybody can prove me wrong.
The problem as I see it is that the "U-Stair, double window return (90º corners only)" configuration does not allow 1 riser to the third flight (or the 1st flight for that matter). Instead it requires 2 risers (1 tread). Or another way to describe it is that there're not configurations that let you start or end on a winder.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Christiaan
If the stair manufacturer can do it, Vectorworks should be able to do it.
But I'm pretty sure this stair geometry is impossible with the Stair Tool so I thought I'd throw it open to see if anybody can prove me wrong.
The problem as I see it is that the "U-Stair, double window return (90º corners only)" configuration does not allow 1 riser to the third flight (or the 1st flight for that matter). Instead it requires 2 risers (1 tread). Or another way to describe it is that there're not configurations that let you start or end on a winder.
staircase_challenge.vwx
Link to comment
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.