I am designing a board 1200x2400mm with 325 holes with a diameter om 20 mm and a vertical and horisontal distance of 96 mm.
Making one hole in the board is not a problem, using the "Push/pull tool:sub face mode". But making it 325 times...! I don't seam to be able to copy/paste a hole. Nore can I select more than one circle at the time to extrude. Any suggestions?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Ragnar
I am designing a board 1200x2400mm with 325 holes with a diameter om 20 mm and a vertical and horisontal distance of 96 mm.
Making one hole in the board is not a problem, using the "Push/pull tool:sub face mode". But making it 325 times...! I don't seam to be able to copy/paste a hole. Nore can I select more than one circle at the time to extrude. Any suggestions?
Link to comment
8 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.