Jump to content

Recommended Posts

Far too often I know that I use this forum as a BMW* sounding board & don't offer Kudos when due. So here goes:

The set position command on the OIP (8-10 years old?) is a great time saver. I spent some time today changing some windows & doors on a project. By using the copy & past of existing measurement to quickly find & make the values on either side of a window equal eg: (325 + 455)/2 I was able to accomplish the task a lot faster than I thought going in. So thanks for that VW! 

 

* B____ Moan & Whine 

  • Like 1

Share this post


Link to post

Yeah it's a bit like the 24hr news cycle around here. Only the controversial stuff tends to see the light of day because all the good stuff usually means you're cracking on with things. So it gives a skewed picture of reality.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×