I was drawing the shape below overtop of a bitmap for tracing. Because I was visually trying to match a shape, I was figuring out the fillets at the joins by trial and error. As I entered values, the fillet tool kept telling me "Fillet radius is too small" so I kept increasing my value. After a couple of tries I realized that the error was giving me incorrect information and I needed a much smaller radius value instead. Can someone else try filleting these joins and confirm this behaviour? Am I missing something here?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Kevin McAllister
I was drawing the shape below overtop of a bitmap for tracing. Because I was visually trying to match a shape, I was figuring out the fillets at the joins by trial and error. As I entered values, the fillet tool kept telling me "Fillet radius is too small" so I kept increasing my value. After a couple of tries I realized that the error was giving me incorrect information and I needed a much smaller radius value instead. Can someone else try filleting these joins and confirm this behaviour? Am I missing something here?
Thanks,
Kevin
Fillet Error.vwx
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.