2024 upgrade glitches-Wall Tags

[Ramon PG]

I updated a 2022 file to 2024 to do some testing. So far its been 3 hours of fixing glitches, there's one I don't have a clue...

 

All my Wall Tags are giving me the correct wall height, except x12. The 2'-0" CMU infills show as 24'-0"; The new 12'-0" CMU walls show as 144'-0".

 

 

 

[Tom W.]

Bit hard to comment without seeing the Wall + the Tag... Can you put one of each in a file + post it?

 

If you remove the association then re associate is it still returning 144 foot?

[Ramon PG]

11 minutes ago, Tom W. said:

Bit hard to comment without seeing the Wall + the Tag... Can you put one of each in a file + post it?

 

If you remove the association then re associate is it still returning 144 foot?

 

Thanks for the reply. For some strange reason the OBJECT FUNCTION and WORKSHEET FUNCTION tag formulas had a "*12" at the end.

[Ramon PG]

Fixed

[Tom W.]

Aha I misread your first post I thought you meant the tag was returning correct height on some walls but not others

[Pat Stanford]

At some point you were probably using that in a file where you wanted the display in inches instead of feet?

[Ramon PG]

2 hours ago, Pat Stanford said:

At some point you were probably using that in a file where you wanted the display in inches instead of feet?

 

Maybe, I can't recall. Thanks Tom and Pat for helping out, much appreciated when stuff seems not to make sense.

[Ramon PG]

FIXED. For some strange reason the OBJECT FUNCTION and WORKSHEET FUNCTION tag formulas had a "*12" at the end.