This seems to be a glitch, has it been spotted ? is it just me? Should I take it personally?🤔
Â
I am carrying out a test so I can be sure I understand how changes I make to a wall style will be represented in different views( top/plan, top, iso) and rendering modes (wireframe, hidden, hidden-dashed, open gl, opengl +hidden foreground). I created 8 sections of the same wall style on a design layer, then created 5 pairs of viewports within a sheet layer.  Â
Â
Â
The issue in drawings 7 is obvious but also shows in drawing 10 (OpenGL +hidden line FG)...two blocks are displaying differently from the rest of the set.
Â
Â
Â
To confirm all the wall segments are the same, and I have tried moving them about within the design layer...it is always these two positions that show the inconsistency, so it must be down to the HL rendering mode. Anyone know what's going on?
Â
While I am here can some one point me to resources/explanations how to (or why I cant) get the hatch information shown on the top/plan view of the walls to display with other rendering modes. Â
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
BobS_50
Hi
Â
This seems to be a glitch, has it been spotted ? is it just me? Should I take it personally?🤔
Â
I am carrying out a test so I can be sure I understand how changes I make to a wall style will be represented in different views( top/plan, top, iso) and rendering modes (wireframe, hidden, hidden-dashed, open gl, opengl +hidden foreground). I created 8 sections of the same wall style on a design layer, then created 5 pairs of viewports within a sheet layer.  Â
Â
Â
The issue in drawings 7 is obvious but also shows in drawing 10 (OpenGL +hidden line FG)...two blocks are displaying differently from the rest of the set.
Â
Â
Â
To confirm all the wall segments are the same, and I have tried moving them about within the design layer...it is always these two positions that show the inconsistency, so it must be down to the HL rendering mode. Anyone know what's going on?
Â
While I am here can some one point me to resources/explanations how to (or why I cant) get the hatch information shown on the top/plan view of the walls to display with other rendering modes. Â
Â
Thanks
Â
Bob S
Â
I am using VW Architect 2019 on PC
Â
Â
 Â
Link to comment
7 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.