I know at some point I will go back & try and make Storeys work. Don't like it, but that's where the software is going I get that. For now I have production to get through & there is a nagging question I can't seem to get since the advent of Storeys. Here's my issues:
- The Layer wall heights no longer seem to work properly. Walls seem to be somewhat arbitrary in how high they are produced. The most recent example is on a renovation. The existing template has the main floor set to a Z of 00 with a layer height of 3050. A site measure gives me an actual height of 3200. Walls are set to Layer wall height but the wall keeps the old 3050 info. If I change the wall to Layer Elevation I then have to mandate the wall height to 3200.
As I say this odd behaviour has been going on for some time now, & I just have to go through at some point & fix every GD wall. My workflow was great until storeys, but this may be a coincidence. My template is a new 2017 file with lots of symbols that have been imported from older iterations that were batch converted.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Jim Smith
I know at some point I will go back & try and make Storeys work. Don't like it, but that's where the software is going I get that. For now I have production to get through & there is a nagging question I can't seem to get since the advent of Storeys. Here's my issues:
- The Layer wall heights no longer seem to work properly. Walls seem to be somewhat arbitrary in how high they are produced. The most recent example is on a renovation. The existing template has the main floor set to a Z of 00 with a layer height of 3050. A site measure gives me an actual height of 3200. Walls are set to Layer wall height but the wall keeps the old 3050 info. If I change the wall to Layer Elevation I then have to mandate the wall height to 3200.
As I say this odd behaviour has been going on for some time now, & I just have to go through at some point & fix every GD wall. My workflow was great until storeys, but this may be a coincidence. My template is a new 2017 file with lots of symbols that have been imported from older iterations that were batch converted.
Any thoughtful tips?
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.