Christiaan Posted June 2, 2017 Share Posted June 2, 2017 Can anyone figure out why the Surface Hatch to one of these objects is not aligned to the Texture? test.vwx Quote Link to comment
0 markdd Posted June 2, 2017 Share Posted June 2, 2017 There is something about the polyline of the faulty extrude that is not aligned with the layer plane. Did you create this using the extract surface command perhaps? If you try and pick the surface using the pick active surface tool it shows a surface at an odd alignment to the layer plane. Could you not retrace quickly and try again? - Frustrating. I have been having problems with surface hatches not aligning in a different way that I will post about later..... 1 Quote Link to comment
0 Christiaan Posted June 2, 2017 Author Share Posted June 2, 2017 (edited) Good spotting. It's a colleague's model. I'll ask him on Monday exactly how he created the two. But it's not really a problem—I've told him just to copy and use the good one—I was just curious how this could happen. Edited June 2, 2017 by Christiaan Quote Link to comment
Question
Christiaan
Can anyone figure out why the Surface Hatch to one of these objects is not aligned to the Texture?
test.vwx
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.