Is there a limit to the classes hierarchy?

[Bruce Kieffer]

I'm trying to set up a three deep classes hierarchy without luck. I do have the dashes correct, but Vectorworks appears to only go two deep on the hierarchy. I want the Sheathing Lower Bottom, the Sheathing Lower Top, the Sheathing Upper Left, and the Sheathing Upper Right grouped with disclosure triangles. I tested with a new document too, same results.

 

 

 

[Tom W.]

The limit is 3 sub-classes, that's why it won't let you create a fourth. I would prefer the limit was greater as I often run into the same thing. I think the BIM conventions or whatever are such that you're only meant to go up to two sub-classes but I don't know anything about that - someone else will say. For me the more the merrier.

[Bruce Kieffer]

2 hours ago, Tom W. said:

The limit is 3 sub-classes, that's why it won't let you create a fourth. I would prefer the limit was greater as I often run into the same thing. I think the BIM conventions or whatever are such that you're only meant to go up to two sub-classes but I don't know anything about that - someone else will say. For me the more the merrier.

I can live with that. I just need to rethink my classes and maybe adds some layers.