I attach a wall that has a wall feature attached to it. The wall has two components, one of the components (the brick cladding), has an offset relative to the wall of - 50 cm
I'd like the wrapping of the feature component be done by the brick cladding but at the correct height. Is this possible?
I tag @Alan Woodwell and @Matt Panzer as you both seem to know very well the wall tools. I would appreciate very much a hand!!
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
martinfdc
Hi,
I attach a wall that has a wall feature attached to it. The wall has two components, one of the components (the brick cladding), has an offset relative to the wall of - 50 cm
I'd like the wrapping of the feature component be done by the brick cladding but at the correct height. Is this possible?
I tag @Alan Woodwell and @Matt Panzer as you both seem to know very well the wall tools. I would appreciate very much a hand!!
Wall Projection and Component Wrap.vwx
Link to comment
5 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.