katerinak Posted May 12, 2015 Share Posted May 12, 2015 Hello, i cannot figure out how to create a 2x6 herringbone hatch in VW 2014. Please help! thank you Katerina Quote Link to comment
AlanW Posted May 15, 2015 Share Posted May 15, 2015 (edited) Hi see attached. (this in in millimetres) Go Modify hatch and set the numbers like this.Because you want each board to over lap the length is 6" plus 1 overlap of 2" so the length is 8" for Level 1 and Level 2. And the dash facter there are 4 patterns till you get a repeat so you need on 75% of the line so the dash factor is 0.75. if it was 1 it would create a full grid HTH Edited May 15, 2015 by Alan Woodwell Quote Link to comment
Mitch Brooks Posted May 15, 2015 Share Posted May 15, 2015 Doesn't this actually give you a hatch of 2" x 4" pavers? Quote Link to comment
Andy Broomell Posted May 15, 2015 Share Posted May 15, 2015 I would also explore a 'Tile' fill as a way of achieving this. The Hatch interface isn't the most intuitive thing in the world... Quote Link to comment
AlanW Posted May 15, 2015 Share Posted May 15, 2015 (edited) Doesn't this actually give you a hatch of 2" x 4" pavers? Doh, Oh yea my maths and brain isn't as it was 40 years ago. But the principle still applies. Will post the new one. Edited May 15, 2015 by Alan Woodwell Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.