BushyRS Posted August 21, 2011 Share Posted August 21, 2011 Hi Is it possible to set the door to have say 150mm layer fo wall before the threshold? I have a wall where the ground falls away and a couple of doors are then "up" the wall as it were, or do i draw then just move? Bushy Quote Link to comment
taoist Posted August 21, 2011 Share Posted August 21, 2011 Are you not using / showing foundation wall? taoist Quote Link to comment
BushyRS Posted August 22, 2011 Author Share Posted August 22, 2011 how does this help? The door is up the wall 225mm so there is a step, not sure how to do this? Quote Link to comment
taoist Posted August 22, 2011 Share Posted August 22, 2011 (edited) Normally, a house has a foundation, floor framing then walls. Openings are set in the walls. The ground is usually below the floor framing and above the footings. Why is the door up the wall about 9"? You may need to add steps or a landing Would you post an image of what you are trying to describe? taoist Edited August 22, 2011 by taoist Quote Link to comment
Mitchell Brooks Posted August 22, 2011 Share Posted August 22, 2011 I don't think that VW allows this. It assumes that a door is at the bottom of its wall. You would have to put your door in a wall, then raise the whole wall your 150 mm, then add a 150 mm section of wall under the first. A workaround for sure. Quote Link to comment
michaelk Posted August 22, 2011 Share Posted August 22, 2011 You can put the door at any height you want. Even if it exceeds the top or bottom of the wall. Insert the door. In the door's OIP enter a value in the height field. (Not Door Height field.) hth mk 1 Quote Link to comment
Mitchell Brooks Posted August 23, 2011 Share Posted August 23, 2011 michaelk nailed this one. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.