Window Top/Plan View Issue VW2024

[Dick Jenkins]

Another issue with the Windows. When I insert windows into a wall and want the jamb to be flush with the exterior side of the wall I get these extended lines ath the jambs. I am using these settings:
Insert Wall - Left Edge

Insertion Relative to: Exterior face of Jamb

 

In 3d  it's fine:

 

[michaelk]

Is that a custom window or two windows directly adjacent to each other?

[Dick Jenkins]

Two windows adjacent to each other. The middle window is a shorter awning window while the two on either side are taller casement windows. The 3D view I showed was another window on the same project.

Edited December 29, 2023 by Dick Jenkins

[michaelk]

Can you copy the wall with that window into a blank file and post it?

 

[Dick Jenkins]

Sure. It is attached.Window file with line at jamb.vwx

[michaelk]

You may have found a bug.

Here's one workaround:

1. Pull the windows out of the wall.  
2. In Settings>General set the Insertion Relative to: Center of Jamb.  
3. Reinsert the window.
4. Offset as necessary.

 

 

[Matt Panzer]

On 12/30/2023 at 5:46 PM, michaelk said:

You may have found a bug.

Here's one workaround:

1. Pull the windows out of the wall.  
2. In Settings>General set the Insertion Relative to: Center of Jamb.  
3. Reinsert the window.
4. Offset as necessary.

 

I can reproduce this and submitted a bug report (VB-201384).

One way around the issue is to select the "Use wall closure" option in the "Plug-in Object Options" or "Plug-in Object Style Options" dialog for the windows.