WhoCanDo Posted November 14, 2023 Share Posted November 14, 2023 Hi, Up until yesterday, my manually placed symbols had an insertion point where I set it. Something went wrong during the day because now the insertion point is at an alternate location. This only happens on one of two computers using the same stationary sheet. The black pic clearly has the insertion point offset from the coloured edited symbol (midpoint). How can I reset it for one computer only? Quote Link to comment
0 markdd Posted November 15, 2023 Share Posted November 15, 2023 Check the Insertion point modes when the Insertion tool is activated. You need to have it on the fourth "Insertion Point" mode. 1 Quote Link to comment
0 WhoCanDo Posted November 15, 2023 Author Share Posted November 15, 2023 How on earth did that change 🤪 In 30yrs, I have never changed that, and I'm not sure I even noticed those options. 😴 Thanks Mark 1 Quote Link to comment
Question
WhoCanDo
Hi,
Up until yesterday, my manually placed symbols had an insertion point where I set it.
Something went wrong during the day because now the insertion point is at an alternate location.
This only happens on one of two computers using the same stationary sheet.
The black pic clearly has the insertion point offset from the coloured edited symbol (midpoint).
How can I reset it for one computer only?
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.