Bunjimun Posted September 29, 2021 Share Posted September 29, 2021 hi folks, so yeah i don't know why im getting these jagged curves on my sheet, you can see the options i have chosen (are they the wrong ones?) Quote Link to comment
EAlexander Posted September 29, 2021 Share Posted September 29, 2021 I think you need to go to your Vectorworks Preferences, and under the EDIT tab and see what your 2d Conversion resolution is at. I keep mine at HIGH. There is also 3d conversion resolution in the 3D tab of preferences. This is also set to HIGH on my system. If these are set to low, this might be causing the issue. Not 100% sure on this, but try it out. e. Quote Link to comment
Andy Broomell Posted September 29, 2021 Share Posted September 29, 2021 And if it's a Section Viewport (can't tell from the screenshot), there's a separate "3D Conversion Resolution" dropdown found by clicking the Advanced Properties button in the viewport's OIP and going to the Display tab. 2 Quote Link to comment
Bunjimun Posted September 29, 2021 Author Share Posted September 29, 2021 1 hour ago, Andy Broomell said: And if it's a Section Viewport (can't tell from the screenshot), there's a separate "3D Conversion Resolution" dropdown found by clicking the Advanced Properties button in the viewport's OIP and going to the Display tab. this was the solution, thank you very much, is there a way to set that as default do you know? Quote Link to comment
Andy Broomell Posted September 29, 2021 Share Posted September 29, 2021 I believe if you make a new Section Viewport with your preferred settings, all future Section Viewports you create will use those same settings upon creation. (Not sure if this applies across files or if it's only in the current file). Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.