Travis.Designer Posted September 17, 2020 Share Posted September 17, 2020 Hi I'm finding a way to add sink model to Base Cabinet. Can it auto cut the top of cabinet in Vectorworks? Thank Travis Quote Link to comment
Diego - Resuelvector Posted September 17, 2020 Share Posted September 17, 2020 With the cabinet tool you can't do that, un-check the countertop from the cabinet, use the Countertop tool and then you can create an opening for the sink, but you will have to manually adjust the size of the hole in the Countertop to fit the sink Quote Link to comment
Joe-SA Posted September 21, 2020 Share Posted September 21, 2020 I find it easier to just make the entire countertop out of a FLOOR object and cut the sink opening out of it instead. 2 Quote Link to comment
Janet Tight Posted April 23, 2022 Share Posted April 23, 2022 Cutting a hole in the countertop works to expose the sink, but the cabinet sides stick through the sink, and I can not clip them out-any suggestions? Quote Link to comment
Guest Wes Gardner Posted April 25, 2022 Share Posted April 25, 2022 @Janet Tight, you CAN "explode" the cabinet into extrudes using the Ungroup command, then you can modify the individual bits...the cabinet will loose its parametric attributes when you do this. Wes Quote Link to comment
michaelk Posted May 4, 2022 Share Posted May 4, 2022 On 4/22/2022 at 6:02 PM, Janet Tight said: Cutting a hole in the countertop works to expose the sink, but the cabinet sides stick through the sink, and I can not clip them out-any suggestions? Make sure the cabinet type is Sink Front (not Standard). And the number of shelves is 0. This will remove all the interior parts of the cabinet. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.