Jump to content

ID label / stamp...

Recommended Posts

In MiniCad, maybe even in VW, there was this great tool "stamp".

At some point it was changed to "ID-label" and , -well I'm sure it's more refined and useful in many ways, - but a little too complicated at times.

I miss the simplicity of the "stamp" tool.

Just clickin' around the drawing with the stamp to get labels with ascending numbers without the need to be attached to specific objects.

Is there still something like it left somewhere? somewhere I have not digged deep enough?

[ 01-26-2006, 12:01 PM: Message edited by: bonus ]

Link to comment

I love the Stamp Tool for Numbering Objects, I

just wish I could define the text block a little

better... when you get to two digit numbers they

insert fine..I continue drawing...look back at

the 2 digit text and it's constrained itself to

look like this:

ex: 12

come back to find this: 1

_disregard lines_______2(right under 1)

as a text block- so I have to manually expand the text block..which is a pain. I've tried to globally to force the desired numberical text to a bigger font size and then reduce it back down, thinking that that would give the text block the space to allow the number to look correct, but to no avail... any thoughts on this?

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...