Kerschbaumer Posted September 27, 2016 Share Posted September 27, 2016 Cant seem to limp along release 12 any longer and I hate change. Have had 2013 for several years but always avoided switching over. The cursor in 2013 has several distracting icons popping up plus white cross hairs when close to end point etc - I find it all very distracting and annoying - I just want the pointer. I have everything switched off as per attached pic but still have all these reference lines, loci etc showing up. Any help is appreciated - Quote Link to comment
Kerschbaumer Posted September 28, 2016 Author Share Posted September 28, 2016 asdf Quote Link to comment
rDesign Posted September 28, 2016 Share Posted September 28, 2016 It may be snapping indicators that are showing up, hard to know without a screen shot of what's happening. Take a look at this 2017 Help page on Snapping, it is probably similar to what you're seeing in 2013: Concept: Snapping Indicators - Vw2017 Help Turn off your snaps and see if they go away, then you can turn back on the snaps you want until you get a hang of things. HTH. Quote Link to comment
EAlexander Posted September 28, 2016 Share Posted September 28, 2016 You want to adjust smart cursor settings which is shortcut with command + 8 I think (not at my computer right now) it's not in settings but part of the pull down menus in your main viewport. Quote Link to comment
Kerschbaumer Posted September 28, 2016 Author Share Posted September 28, 2016 Thanks all for the help- the smart cursor settings helps a lot to clear the clutter and will follow up on the link from rdesign tomorrow am. Quote Link to comment
Kerschbaumer Posted September 28, 2016 Author Share Posted September 28, 2016 Am getting closer - Is there any to turn off the snap point indicator - (I run a black blackground)that is the white cross hairs that come up when in proximity to a snap point? Quote Link to comment
rDesign Posted September 28, 2016 Share Posted September 28, 2016 (edited) Take a look at this Help page on 'Configuring Interactive Display' (it's for 2015 but should be similar to 2013). Under Tools > Options > Vectorworks Preferences, on the Interactive tab click 'Interactive Appearance Settings' and you'll find a section for SmartCursor. I think you're seeing either the Selection or Snap box. You can change the size of the Selection and Snap Boxes, but I don't think you can turn them off without turning off snapping altogether. Edited September 28, 2016 by rDesign Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.