Hi Guys, here's a trip down memory lane for some (most?) of you, but I'm using VW10 (not 2010!). Anyhow, I'm importing a dwg file to rescale it and no matter what I do, it seems that there are some arrowheads from the autocad drawing that refuse to rescale. I have ungrouped the items before rescaling but they refuse to play ball. the attributes are showing that they are classified as polygons, but the selection areas are differing sizes, some just the arrow, others are a much larger boundry. I'm sure I had the solution to a similar problem when I was using VW12.5, but typically, I'm now wasting too much time trying to remember/experiment, whereas I'm sure there will be a flurry of answers from the forum (even if it is just to gloat over your much higher spec VW versions and tell me what a numpty I am for missing a blatantly obvious point :grin: )
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
SteveW
Hi Guys, here's a trip down memory lane for some (most?) of you, but I'm using VW10 (not 2010!). Anyhow, I'm importing a dwg file to rescale it and no matter what I do, it seems that there are some arrowheads from the autocad drawing that refuse to rescale. I have ungrouped the items before rescaling but they refuse to play ball. the attributes are showing that they are classified as polygons, but the selection areas are differing sizes, some just the arrow, others are a much larger boundry. I'm sure I had the solution to a similar problem when I was using VW12.5, but typically, I'm now wasting too much time trying to remember/experiment, whereas I'm sure there will be a flurry of answers from the forum (even if it is just to gloat over your much higher spec VW versions and tell me what a numpty I am for missing a blatantly obvious point :grin: )
Link to comment
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.