I have noticed recently that some symbols and objects, usually World based, don't share the same Z axis zero point.
In the attached file I have a stick of 12" Prolyte truss from the VW library that is good and an Applied 16" truss symbol extracted from a DWG file where I have to 3d move the truss up 8" to react the same zero Z as the Prolyte.
Can someone explain what's happening here and how I can change the symbol and any future symbols to avoid this?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Jake Wilson
I have noticed recently that some symbols and objects, usually World based, don't share the same Z axis zero point.
In the attached file I have a stick of 12" Prolyte truss from the VW library that is good and an Applied 16" truss symbol extracted from a DWG file where I have to 3d move the truss up 8" to react the same zero Z as the Prolyte.
Can someone explain what's happening here and how I can change the symbol and any future symbols to avoid this?
truss Z.vwx
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.