Leandrovsk Posted September 24, 2023 Share Posted September 24, 2023 I have two slabs with different heights, the wall is positioned on the higher slab. The slab was generated with the room command by selecting the walls. Until here, everything is fine. However, when I try to add a door, it is at the height of the lower slab. Quote Link to comment
Tom W. Posted September 24, 2023 Share Posted September 24, 2023 A Door should I believe insert by default at the bottom of a Wall so not sure what's happened in your case: is there a bottom offset applied to the Wall component/s? Otherwise look at the Z height for the Door in the OIP + raise it to the correct height there. 1 Quote Link to comment
Leandrovsk Posted September 25, 2023 Author Share Posted September 25, 2023 It's strange really, the door isn't at the base of the wall but in the slab below. Anyway, I solved it as you said, by raising the height. Thank you. Quote Link to comment
techdef Posted October 17, 2023 Share Posted October 17, 2023 Yes, very annoying 'feature' that doors insert to bottom of wall, not to Finish Floor height. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.