Help Aligning wall sheathing to underside of roof sheathing

[Todd W]

I am trying to align the exterior sheathing to the underside of the roof sheathing. How do I do this? A clip of the model attached. I have the roof datum set to the underside of the sheathing.

 

Thanks.

 

[Tom W.]

Apply a top offset to the sheathing component in the wall settings

[Todd W]

Thanks Tom - I found that when I set the offset slightly higher than the underside of sheathing then clip it with the roof sheathing it hits the underside where I want it to.

 

 

[Tom W.]

4 minutes ago, Todd W said:

Thanks Tom - I found that when I set the offset slightly higher than the underside of sheathing then clip it with the roof sheathing it hits the underside where I want it to.

 

 

 

On the eaves that's exactly what you need to do. Unless you actually want a square top edge to the boards, abutting the underside of the roof, which is more likely how it would be constructed in reality...?