I haven't done any 3D for a while so not sure if I am just a bit rusty but simply cannot get my site modifiers to interact with my site model.
I've tried creating using the Pad tool and by converting existing shapes into site modifiers with no joy. I 've played around with elevations but the pads simply show as shapes with no impact on my site model at all?
I've attached a couple of screenshots with just a simple circular site modifier. Even though I have just created this, as you can I dont get the 'candystripe' to show the site model needs updating and it hasn't had any impact at all
I've used pads before and cant think what I am doing differently 🤔
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
ChrissieB
Hi
I haven't done any 3D for a while so not sure if I am just a bit rusty but simply cannot get my site modifiers to interact with my site model.
I've tried creating using the Pad tool and by converting existing shapes into site modifiers with no joy. I 've played around with elevations but the pads simply show as shapes with no impact on my site model at all?
I've attached a couple of screenshots with just a simple circular site modifier. Even though I have just created this, as you can I dont get the 'candystripe' to show the site model needs updating and it hasn't had any impact at all
I've used pads before and cant think what I am doing differently 🤔
Thank you
Christine
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.