Dan Menitoff Posted March 1, 2022 Share Posted March 1, 2022 Hi all - 'm trying to place two 10x12" vent louvers in an overhead garage door, in the bottom panel on the left and right of the door. I see there is a louver section in the settings but I can't get two vents where I want them....Any help is appreciated. Quote Link to comment
0 Pat Stanford Posted March 1, 2022 Share Posted March 1, 2022 I don't think that is an option with the stock Overhead Door. You will probably need to model the door as a symbol and use the Use Symbol Geometry option to get the display you want. 2 Quote Link to comment
0 Dan Menitoff Posted March 2, 2022 Author Share Posted March 2, 2022 Thanks Pat - I'll give it a try! Quote Link to comment
0 Vectorworks, Inc Employee Judah Warshaw Posted March 3, 2022 Vectorworks, Inc Employee Share Posted March 3, 2022 Another option is the Custom Leaf setting. This way you do not have to model the entire door, including the jamb and any other options you would like. Just the leaf. And you may find one that is a good starter to work from: 2 Quote Link to comment
Question
Dan Menitoff
Hi all -
'm trying to place two 10x12" vent louvers in an overhead garage door, in the bottom panel on the left and right of the door.
I see there is a louver section in the settings but I can't get two vents where I want them....Any help is appreciated.
Link to comment
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.