Phil hunt Posted February 23, 2014 Share Posted February 23, 2014 (edited) i have a section of ground that has a platform 25m x 20m with 4 differing levels in the top left hand corner from floor level its 610mm below in the top right hand corner its 2m below floor level in the bottom right hand corner its 1m below floor level and in the bottom left hand corner its level any ideas please basically the site slopes in 2 different plains !!!! Edited February 23, 2014 by Phil hunt Quote Link to comment
Phil hunt Posted February 23, 2014 Author Share Posted February 23, 2014 i need to model the platform so a structure will lit on top but i want to show the slopes of the site on an elevation as you can see from the visuals i have extruded a block to 2m and them another one angled on 2 planes and made a solid subtraction its works up to a point but its more luck than accuracy Quote Link to comment
CipesDesign Posted February 23, 2014 Share Posted February 23, 2014 If you know the relative elevations of the corners you could make a simple Site Model from that data? Quote Link to comment
Phil hunt Posted February 23, 2014 Author Share Posted February 23, 2014 Hi peter that's something I haven't done in vectorworks yet I'll have to read up on it are there any videos available that you know of. Thanks peter Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.