blackisleboy2 Posted April 7, 2009 Share Posted April 7, 2009 Hi all, No doubt an easy one, but not sure how to do it! I'm trying to model our office, which has a sloped ceiling - wall height 232cm at one side and 274cm on the other. How do I make the wall in VW have a different height at one end from the other? I see I can fit walls to roof, but I don't know how to make a roof yet... Thanks in advance, Graham Quote Link to comment
Peter Eichel Posted April 7, 2009 Share Posted April 7, 2009 Double click on the wall in a perspective view, grab one of the blue dots and drag it where you need it. You may need to turn on your scale option. Quote Link to comment
blackisleboy2 Posted April 7, 2009 Author Share Posted April 7, 2009 Thanks Peter, much appreciated! Quote Link to comment
beanus Posted April 7, 2009 Share Posted April 7, 2009 how do you turn on the scale option Quote Link to comment
islandmon Posted April 7, 2009 Share Posted April 7, 2009 I see I can fit walls to roof, but I don't know how to make a roof yet... just use a 3dPoly and then follow the 'Fit Walls to Roof " dialog and then point to the Layer. Quote Link to comment
Peter Eichel Posted April 7, 2009 Share Posted April 7, 2009 Near the top left corner is a small box which reads "enable interactive scaling mode" when you move your mouse over it. Click on it to turn it on or off. Draw a rectangle and grab a corner in both on and off mode and you'll see what it does. Works with lines and other entities also. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.