I would like it if after a wall has been "fit to roof" if it could be undone.
Or if aftr a wall has ben "fit to roof" the lower hieght and upper height were displayed in the OIP so at least it could be manually reverted.
What are people doing at the moment?
As far as I can see the two options are: redraw the walls or manually select each wall and use the 3D locis to drag the points down. (great for large plans)
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
CS1
I would like it if after a wall has been "fit to roof" if it could be undone.
Or if aftr a wall has ben "fit to roof" the lower hieght and upper height were displayed in the OIP so at least it could be manually reverted.
What are people doing at the moment?
As far as I can see the two options are: redraw the walls or manually select each wall and use the 3D locis to drag the points down. (great for large plans)
Link to comment
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.