eric.rktek Posted February 5, 2008 Share Posted February 5, 2008 I've been using the rotate view tool a lot lately and find it very handy. However, I'm running into a little glitch when holding down the shift key in order to constrain an angle for a line or wall to extend it from a handle. The line/wall tends to jump out into space instead of holding the angle properly. The extension works fine once the view is shifted back to regular plan view. Quote Link to comment
michael john williams Posted February 5, 2008 Share Posted February 5, 2008 Seems the shift key also sends walls off by 1 degree, which we have only just noticed and they are building the house?!! Quote Link to comment
RGyori Posted February 5, 2008 Share Posted February 5, 2008 Eric and mw, do you have SP2 (build 83388) installed? I too encountered the same problems with rotated plans until installing the latest build. I have not been able to duplicate the problems since then. Bob Quote Link to comment
eric.rktek Posted February 5, 2008 Author Share Posted February 5, 2008 Bob, Thanks for the tip. I'm working with the older SP2 update. Getting the new one now. Quote Link to comment
michael john williams Posted February 6, 2008 Share Posted February 6, 2008 Not installed SP2 yet. Quote Link to comment
Guest Posted February 6, 2008 Share Posted February 6, 2008 The latest build of SP2 addresses this, amongst a few other issues. It's not a bad idea to go ahead and update to this revision. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.