Jump to content
  • 0
Sign in to follow this  
lucylou

Page set up/print changed in VW2008

Question

More queries!!!....

as said in yesterdays posts we installed VW2008 yesterday and are just getting to know it (or not as the case may be!) we have now tried printing and our page setup in the sheet layer has moved about 10mm so it now cuts off the end of our page! dont know why this has happend. do we have to physically move the 'page' to now fit our layout? (on every single page of every single project???....yawn!)

(sorry if it doesn't make sense but its hard to describe without seeing it!)

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...