Jump to content
  • 0
Sign in to follow this  
bob cleaver

plotting with panther

Question

I cannot plot VW 10.5.1b files using panther (mac) on my HP designjet 800ps. Although an image prints, the sheet orientation does not register properly. I am using a custom sheet size to produce 24" x 36" sheets on the 24" wide plotter. The image that prints is a portion of the sheet. I have tried several configurations with no luck.

I tried HP in Boise and they know of the problem, but the guy I spoke with knew of no solution.

I really like panther's interface and wish to solve the problem.

Thank you in advance- Bob

Share this post


Link to post

1 answer to this question

Recommended Posts

  • 0

I was able to plot after using the preset drawing sizes (arch D) in page setup. The sheet is 37 3/8" long due to a hard margin HP adds to the sheet. My earlier solution was a cutom sheet size that is not a valid solution using panther.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...