I have just installed VW2024 and updated today for the latest. I used to be able to draw a complex closed shape or shapes, then offset them with the offset tool to the outside if I clicked outside all the shapes, or to the inside if I clicked inside any of the shapes. If any lines overlapped, it would refuse to do anything till I resolved that, which works. I knew to resolve the issue if nothing happened.
Now I have so shapes that I could dearly like to offset 300mm outwards. I have cut the main shape Into smaller, simpler shapes, and this corrects it for most. I made sure there were no cutouts. This one shape persists in offsetting inwards. Obviously I can do workarounds, but this should not be necessary. Any ideas?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
TessF
Hi all,
I have just installed VW2024 and updated today for the latest. I used to be able to draw a complex closed shape or shapes, then offset them with the offset tool to the outside if I clicked outside all the shapes, or to the inside if I clicked inside any of the shapes. If any lines overlapped, it would refuse to do anything till I resolved that, which works. I knew to resolve the issue if nothing happened.
Now I have so shapes that I could dearly like to offset 300mm outwards. I have cut the main shape Into smaller, simpler shapes, and this corrects it for most. I made sure there were no cutouts. This one shape persists in offsetting inwards. Obviously I can do workarounds, but this should not be necessary. Any ideas?
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.