Separate objects in Section Viewports

[jmcewen]

I suspect this is a simple one that I have just missed.

 

When I create a section viewport, every object along the cutting line appears in section as though they were a single object, with the hatch continuous across all objects.  Is there a setting somewhere to allow the objects to appear separate?  it seems there should be. That is half the point of a section viewport in my mind-- to see the layers of parts that go into an assembly.

[markdd]

Go to the Advanced Properties of the Viewport and select Separate Cross Sections from the Attributes Tab.

 

That should do it....

[jmcewen]

58 minutes ago, markdd said:

Go to the Advanced Properties of the Viewport and select Separate Cross Sections from the Attributes Tab.

 

That should do it....

Thank you.  Advanced Properties had run off the bottom of my OIP so I had not found it.  This will save me a lot of time today.  I have a ton of sections to plate, and I did not want to need to draw the object separations in the annotations!