Wall Component (Gypsum interior finish) not extending up to the Roof

[armangill]

Hello All,

 

I am having some issues with drawing and my inner gypsum wall board finish is not extending to meet up with the underside of my roof. I am not too sure why but I have been trying everything in the wall style editing tool to try and change this but can't seem to get this figured out. 

 

Hoping someone can please help me with this!

[Tom W.]

Make sure you have 'Follow top wall peaks' enabled for the gypsum component in the Wall Settings + that it doesn't have a Top Offset applied...

[armangill]

Hi Tom, 

 

Please find my current settings attached. I believe that it should be extending but it is not

[Tom W.]

OK... Do you have a Roof which is set to clip those components?

 

What happens if you run the delete wall peaks command then run fit walls to objects again on the gables?

 

Can you post the file?

 

Edit: sorry I can see roof in top screenshot now. So I would try deleting top wall peaks + starting again. Also, your component settings I think are for the style but these can be overridden for the wall instance so double check the Wall Components settings for each wall in the OIP as well... Here just Component Top + Component Bot will be editable, everything else will be greyed-out. 

 

 

 

Edited December 15, 2022 by Tom W.