I hope I'm missing something, as this seems so obvious for so long:
Currently the placement of the first dimension is arbitrary so,
I'd like to see a setting where dimensions can be placed neatly and consistently with a pre-defined offset from the measured object for the first placement.
(see the Dimension Exterior Walls command preference)
In fact an editable list of such presets would be a nice update on the single 0.4" shown here.
So as an example
Offset 1> 12"
Offset 2>+8"
Offset 3>+6"
4th & subsequent offsets>+4' or whatever you'd like
This could then be disabled/enabled on the fly with the Opt/Alt key
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
bcd
I hope I'm missing something, as this seems so obvious for so long:
Currently the placement of the first dimension is arbitrary so,
I'd like to see a setting where dimensions can be placed neatly and consistently with a pre-defined offset from the measured object for the first placement.
(see the Dimension Exterior Walls command preference)
In fact an editable list of such presets would be a nice update on the single 0.4" shown here.
So as an example
Offset 1> 12"
Offset 2>+8"
Offset 3>+6"
4th & subsequent offsets>+4' or whatever you'd like
This could then be disabled/enabled on the fly with the Opt/Alt key
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.