Yellowstone Construction Posted March 31, 2006 Share Posted March 31, 2006 Ok. I have adjusted opacity on many different layers and I don't see any difference. What does this do and where does it do it? -Mike Quote Link to comment
CipesDesign Posted March 31, 2006 Share Posted March 31, 2006 You will notice the varying degrees of opacity when two (or more)layers are visible at the same. So for example, if you have a roof plan layer and a floor plan layer, in normal circumstances the roof layer would be "on top of" the plan layer. therefore it would be impossible to see the walls of the plan if both layers were visible. But if the roof layer had a lower than 100% opacity setting (say 60% for example), the walls below would show right through. This is true for any situation where you show multiple layer simultaneously, including in VP's.... Quote Link to comment
Guest Posted April 7, 2006 Share Posted April 7, 2006 .. and Quartz needs to be turned on in VW Preferences. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.