Jump to content
Sign in to follow this  
mark becker

hp designjet 120nr

Recommended Posts

Mark, you don't mention which OS you are using. Look at the VectorWorks options in Print and Print Setup. Make sure the printer resolutions are correct. What exactly is causing you problems? Line weight? Jaggies on curved lines?

Share this post

Link to post

I have purchased a 120 and have found that with the res set to 300 dpi and in best mode (printing on ISCA plain paper) the plans come out sharp and accurate (on OSX 10.2.6), I haven't tried it at other resolutions but I have noticed that when set to normal mode the print is jagged (I use Vectorworks for designing film sets)

Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...