Jump to content

mark becker

Member
  • Content Count

    6
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

About mark becker

  • Rank
    Greenhorn

Personal Information

  • Occupation
    designer
  • Location
    mill valley, ca
  1. I have vectorwrks 10 architect and a mac G4 runnning system 10.2.3 and am considering purchasing an epson 7600. I owned a 7500 but was disappointed by not being able to run it in system 10 (epson did not have system drivers for it) and also the lack of longevity with the print heads. Any opinions on the 7600 regarding these issues?
  2. I'm not sure if this is the same issue, but what I would like to be able to do is create a wall in plan view only, and ultimately be able to apply a fill, from four lines. How do I do that?
  3. I'm wondering if anyone has some tips for how to get better quality results using the hp120nr with vectorworks 10. If I use the 300 dpi setting the results are not very sharp and if I try to up the dpi it automatically tiles my drawings into smaller pages, not allowing the arch D size. Any suggestions?
  4. Thanks Peter, just what I needed to know! Now if I could only get this hp laserjet 120 NR to print with some clarity.
  5. I just purchased a HP designjet 120nr and have found the quality of the printing extremely disappointing. Any suggestions?
  6. When I bought an epson printer I had to arrange for my vectorworks 10 to open in classic(os9). I've replaced that printer and can't remember how I changed this? How can I change it back to open in osx?

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...