Leppi Posted February 14, 2020 Share Posted February 14, 2020 (edited) Hi, yesterday we recognised a big problem within Vectorworks. We're using the German Version with SP2.1.1 R1 (build 523565). We had a pipe attached on a truss witth cantilever to both side. There were single point loads on the pipe about 20cm away from the truss and we get the message that the load can not be attached to two strucural elements. I did a test with Symbols from the library, so not using ours. As you can see the single point load is not at the truss, and I don't get a warning that the load is not attached. It is also included in the calculation. When i change the Trim hight of the system, loads height also will change. Anyone else got this problem? Best regards from Berlin, Germany Sebastian Edited February 14, 2020 by Leppi Quote Link to comment
Vectorworks, Inc Employee jcogdell Posted February 15, 2020 Vectorworks, Inc Employee Share Posted February 15, 2020 Hi Sebastian can you pm me the file so I can have a look? Gruße Jesse Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.