Jump to content
39Tech

Pipe Load attaching to System Load ?

Recommended Posts

So I have lighting attached to a lighting pipe connected to truss.  I have the truss connection diamond showing the pipe connection.  When I select the system and run a calculation the pipe is not added to calc.  Any ideas?  It shows the connection highlighted but not the Pipe or the lights.  

 1244971493_ScreenShot2018-12-12at9_57_21AM.thumb.png.af16fe881d1ca64b11c384114aa4b731.png

Share this post


Link to post

Hello,

They might have become disconnected so it would be worth redoing the connection again. It works in my simple test.

One thing I have found is that if you select the truss and in the OIP choose 'Select System Objects' the pipe isn't selected. If I only select the pipe and in the OIP choose 'Select Truss System' only the pipe and any loads attached are selected but not the truss. This is confusing IMO.

 

Cheers,

Peter

 

Screen Shot 2018-12-21 at 10.20.18 am.png

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...