Jump to content
  • 0
Sign in to follow this  
David Poiron

Stair Walk Line and Classes

Question

I was just thinking that in the class definition the two markers could be labeled (and act as) start and end and could correspond to those for the walk line. This would perhaps be more consistent behaviour - currently I have to override the stair walk line markers to get them to point in the right direction.

Share this post


Link to post

2 answers to this question

Recommended Posts

  • 0

Alan, I was using this but it was not working because I had the graphic attribute was set to class for the walk line and apparently this does not follow the class markers properly. I overrode this setting and it works fine now. The request above was to tie the class setting markers to the stair walk line which is currently not the case.

Edited by David Poiron

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×