Jump to content
  • 0
kuniko juniper

VW not starting after installation


Hi - I just bought and installed the latest version of VW on a year old IMac pro which seemed to have all the required hardware to run the software. The installation seemed fine and an icon appeared on the bottom but when I clicked to start the program it just gives a small box in the middle of the screen and then a circling image showing something is moving. It stays like this until using force quite where it advises that VW is not responding. Is it advisable to uninstall and retry as a first option - any other suggestions??



Share this post

Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...