I have to say, SP2 really helped a lot of the bugs out. However I am curious about the hoist chain cross section only having a fibercore option set available and not typical chain used with hoists? My rigging numbers were off significantly because most of the truss symbols do not have cross sections added to them as of yet, and by default are Rigid, (which can really mess you up if you dont pay attention) Does a Rigid chain cross section do the same?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
CETLV
I have to say, SP2 really helped a lot of the bugs out. However I am curious about the hoist chain cross section only having a fibercore option set available and not typical chain used with hoists? My rigging numbers were off significantly because most of the truss symbols do not have cross sections added to them as of yet, and by default are Rigid, (which can really mess you up if you dont pay attention) Does a Rigid chain cross section do the same?
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.