Jump to content
Marcb

How to extend a line?

Recommended Posts

Hello,

 

I am trying to extend a line in Vectorworks 2016 on a mac. It is not long enough, and I would like to extend it a certain distance. I know in autocad there is an extend command, is there something like that in Vectorworks?

 

Thanks!

 

Share this post


Link to post

This goes into greater detailed than needed, but explains the basic method of reshaping objects (control points) which also applies to lines:

 

 

If you're extending the line TO some other geometry, this may also be useful:
 

 

Share this post


Link to post
1 hour ago, Marcb said:

I would like to extend it a certain distance.

 

I would :

Select the Line

In Object Info Palette set the origin to start or end point

Set coordinates to polar if needed

Click in Length number field to activate

click behind current length number

Add +x.xx distance behind the length number

press ENTER

  • Like 1

Share this post


Link to post

What zoomer said, but with one key addition. See the image below:

 

Capture.JPG.60ff53ee850a05e07ecce40fadfff2f4.JPG

 

I've circled 2 key pieces that aren't clearly marked. The grid and circle with a dot switch the line from rectangular to polar coordinates. You can switch at will, it does not change the line in any way. 

 

The 3 dots below indicate something called "segment position." If you extend the line with the current setting, the additional length will go to the right. If you click the center dot, any extension will go equally to either side. Note that this applies to 2 dimensional shapes too, but there are 9 dots instead of 3.

 

-Dan

  • Like 1

Share this post


Link to post

That is what I meant by :

 

13 hours ago, zoomer said:

In Object Info Palette set the origin to start or end point

Set coordinates to polar if needed

 

 

But thanks for the illustration, that makes it much better understandable.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...