XOP15 Posted May 7, 2009 Share Posted May 7, 2009 Hi All, Sure there is a simple way round this, I just don't know it !! I have draw some truss using the truss tool in VW Spotlight and sections of it are showing red even in final renderings of it, I guess this is because that some of the section are not the same lengths as the others, is there a way of turning the red off ? Cheers, Dave. Quote Link to comment
MattG Posted May 7, 2009 Share Posted May 7, 2009 (edited) Yes. There is a highlight check box at the bottom of the oip when you have the truss made by the truss tool selected. That should get rid of it. The reason this is happening is because your length and connection interval aren't playing well with each other. In your oip there is a drop down that says connection type. If you have anything selected then it needs to use your connection interval. Say I have a 13' truss and my connection interval is 5'. It will highlight the 3' at the end to indicate the error and you can resolve it however you see fit. doe that help? Matt Edited May 7, 2009 by MattG Quote Link to comment
XOP15 Posted May 8, 2009 Author Share Posted May 8, 2009 Hi Mat, Thanks for your reply, that works just fine for me. Many Thanks. Dave. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.